GENERATOR OPERATION
YDG Operation Manual
77
AC APPLICATION
1. Start the engine and make sure the voltage
meter (Figure 7, (1)) or (Figure 8, (4))
indicates the voltage. If it does not, the
generator or voltage meter may be damaged.
Model YDG2700EV-6EH
Models YDG3700EV-6EI and YDG5500EV-6EI
2. Plug in the appliance.
Note: If an overload trips the AC circuit
protector, reduce the electrical load on
the circuit and wait a few minutes before
resuming operation.
NEUTRAL BONDED
TO FRAME
BATTERY CHARGE ONLY
DC12V 8.3A
OFF
DC
BREAKER
ON
AC
SW
AC 120V
TOTAL
20.8A
20A
STA RT E R
SW
OFF
ON
STA RT
240
120
0
0
~
V
(
1
)
(
2
)
(
3
)
0002439A
Figure 7
1. Voltage Meter
2. 120V AC GFCI Unit Receptacle
3. 12V DC Output Terminal (For 12 Volt DC
Battery Charging Only).
CAUTION
Be sure that all appliances are in good
working order before connecting them
to the generator. If an appliance begins
to operate abnormally, becomes
sluggish or stops suddenly, turn off the
generator main switch immediately.
Then disconnect the appliance and
examine it for signs of malfunction.
0000169en
BATTERY CHARGE ONLY
DC12V 8.3A
AC120V/240V
AC120V 41.6 A
DC
BREAKER
AC
SW
20.8 A
20A
30A
STARTER SW
OFF
ON
STA RT
NEUTRAL BONDED TO FRAME
240V
120V
V
240
120
0
0
~
(
1
)(
2
)
(
3
)
(
4
)
(
5
)
0002440A
Figure 8
1. 120 / 240V AC Twist Lock Receptacle
2. 120V AC GFCI Unit (Receptacle)
3. 120V AC Twist Lock Receptacle
4. Voltage Meter
5. 12V DC Output Terminal (For 12 Volt DC
Battery Charging Only)
To Next Page
Loading...
