36
Operating the tractor
2)
Slow return valve
IMPORTANT
Do not pull control lever to raise when stop valve
is
closed.
Excessive
'peed
Of
drop may
cause
damage
Or
Open stop valve completely when
it
is
not in use.
injury. Fully lowering implement should require
at least two seconds.
Do not close stop valve when transporting
imple-
ment.
This valve controls lowering speed of
hydraulic
lift.
Hydraulic
lift
faster
If
you like to lock the hydraulic lift for safety, use
when
a
heavy implement
is
attached. Adjust
valve.
~h~
valve
can
be use
as
stop
lowering speed so that
is
slow enough to be
valve
at
the
slowest
position.
safe.
4)
Feed back arm and
rod
The feed back arm and rod on the left hand
side lift arm are for position control.
The arm has two holes for connecting with
feed back rod. Upper hole
(P)
should be
used for position control.
IMPORTANT
-
Do not adjust the length of feed back rod.
Do not use lower hole
(Dl.
3)
Stop valve
You can lock hydraulic lift in position, so
it
can not be raised or lowered, by closing stop
valve. Turn knob clockwise to stop when
sewicing an implement beneath
it.
I
Fed
>od
'
\
~dsii'ian
IP)
Position
I01
stop
valve
24031
To Next Page
Loading...
