20 support@yardistrystructures.com
2- Gusset Right
2- Gusset Left
8- 5/16 x 3-1/4" Hex Bolts
(5/16 large washer, lock
washer, T nut)
4- 1/4 x 1-15/16" Hex Lag
(5/16 Large Washer)
Step 5: Frame Assembly
Part 2 - Short Side
Note: The bevelled ends on each gusset
should always face away from the wood it is
attaching to.
C: Make sure each Short Side assembly is
square with the Post Assemblies then facing
one Short Beam Assembly from the outside
place one (740) Short Right Gusset on the
right hand side so the top ts tight to the Short
Beam Assembly and the bottom ts tight to the
Post Assembly. Attach gusset to Short Beam
Assembly with two 5/16 x 3-1/4” Hex Bolts
(with 5/16” lock washer, 1/4-5/16” large washer
and 5/16” t-nut). Pre-drill with a 1/8” drill bit
then attach to Post Assembly with three 1/4
x 1-15/16” Lag Screws (with 1/4-5/16” large
washer). (F5.4 and F5.5)
D: Repeat Step C on the left hand side with one
(739) Short Left Gusset. (F5.4 and F5.5)
Hardware
12 x 1/4 x 1-15/16” Lag Screw (1/4-5/16” large washer)
8 x 5/16 x 3-1/4” Hex Bolt
(5/16” lock washer, 1/4-5/16” large washer, 5/16” t-nut)
Wood Parts
2 x (740) Short Right Gusset
2 x (739) Short Left Gusset
F5.4
2- Gusset Right
2- Gusset Left
8- 5/16 x 3-1/4" Hex Bolts
(5/16 large washer, lock
washer, T nut)
4- 1/4 x 1-15/16" Hex Lag
(5/16 Large Washer)
Post
Assembly
5/16” T-nut
5/16” Lock
Washer
5/16 x 3-1/4”
Hex Bolt
1/4-5/16”
Large Washer
1/4-5/16”
Large
Washer
1/4 x 1-15/16”
Lag Screw
(739) Short
Left Gusset
(740) Short
Right Gusset
Short Beam
Assembly
Post Assembly
Tight
Tight
Gusset
Short Beam
Assembly
F5.5
To Next Page
Loading...
