To Next Page

To Previous Page

model no. 054-5756-6 | contact us: 1.866.523.5218 model no. 054-5756-6 | contact us: 1.866.523.5218

MAINTENANCE

• Lift the tip of the guide bar up to check for the sag.

• Release the tip of the guide bar and turn the chain tensioning bolt 1/2 turn clockwise.

Repeat this process until the sag does not exist.

• Hold the tip of the guide bar up and tighten the chain cover lock bolt. The chain is

correctly tensioned when there is no sag on the underside of the guide bar, the chain is

snug, but it can be turned by hand without binding.



NOTE: The saw chain is properly tensioned if, in the middle of the

guide bar, it can be lifted 3mm to 4mm from the edge of the guide bar.



NOTE: If the chain is too tight, it will not rotate. Loosen the chain cover

lock knob slightly and turn the chain tensioning knob 1/4 turn counter-

clockwise. Lift the tip of the guide bar up and retighten the chain cover

lock knob. Ensure that the chain will rotate without binding.

Yardworks 054-5756-6 User Manual

Questions and Answers: