Yardworks 054-5757-2 User Manual

model number 054-5757-2 | contact us: 1.866.523.5218
22
!
WARNING!
• Before attaching the power cord of the machine to the power cord of the extension
pole, make sure that the tool is switched off and unplugged from the power supply.
 8IFOVTJOHUIJTNBDIJOFXJUIUIFFYUFOTJPOQPMFNBLFTVSFUPªSTUBUUBDIUIF
power cord of the machine to the power cord of the extension pole, and then attach
the power cord of the extension pole to power supply.
• ELECTROCUTION HAZARD:
Never use the saw or extension pole in an area with overhead power lines or where
the branch being cut can come into contact with overhead power lines.
ADJUSTING POLE LENGTH
The pole saw has a telescoping pole assembly that will extend from 89 11/16” (227.8 cm) (fully
retracted) to 119 3/8” (303.3 cm) (fully extended).
A cam-levered collet is used to hold the pole in position at any extended length.
1. To extend the pole, loosen the clamping lever as shown in Fig . F. Pole will slide freely.
2. Pull inner pole section out to desired length of extension. Note: only extend pole to
minimum length required to reach limb that is being cut.
3. To lock pole in position, tighten clamping lever as shown in Fig. F.
D1 D2
1
2
2
1
E1
E2
Assembly

Yardworks 054-5757-2 Specifications

General

Brand	Yardworks
Model	054-5757-2
Category	Chainsaw
Language	English