Yardworks 054-5757-2 - Cutting Techniques and Safety

model number 054-5757-2 | contact us: 1.866.523.5218
23
OPERATION
POWER ON/OFF
1. SWITCHING ON AND OFF (See Fig. G)
!
ATTENTION: Check the voltage and current supply: The voltage and current supply
must comply with the ratings on the product plate.
For switching on the tool, press the Lock-off Button (3), then fully press the On/Off Switch (2)
and hold in this position. The Lock-off Button can now be released.
For switching off, release the On/Off Switch.
2. CUTTING WITH CHAINSAW
!
*NQPSUBOU*TUIFPJMSFTFSWPJSªMMFE $IFDLUIF0JM-FWFM8JOEPX4FF'JH)
QSJPSUPTUBSUJOHBOESFHVMBSMZEVSJOHPQFSBUJPO3FªMMPJMXIFOPJMMFWFMJTMPX"GVMMPJM
tank will last approximately 12 minutes of cutting depending on sawing intensity and
stops.
Check recently replaced chain tension about every 10 minutes during operation.
(1) Connect saw to extension cord. Connect extension cord to power supply. (See Fig. I)
1
2
3
F
1
2
G
Assembly