Yardworks 054-5757-2 - Lubricating Sprocket

model number 054-5757-2 | contact us: 1.866.523.5218
32
Keep chain sharp. Your saw will cut faster and more safely. A dull chain will cause undue
sprocket, guide bar, chain, and motor wear. If you must force chain into wood and cutting
creates only sawdust with few large chips, chain is dull.
LUBRICATING SPROCKET
!
WARNING
Wear heavy-duty gloves when performing any maintenance or service to this tool.
Always unplug the tool before performing any service or maintenance on this tool.
NOTE:
It is not necessary to remove the chain or bar when lubricating the guide bar sprocket.
1. Clean the bar and sprocket.
 6TJOHBHSFBTFHVOJOTFSUUIFUJQPGUIFHVOJOUPUIFMVCSJDBUJPOIPMFBOEJOKFDUHSFBTFVOUJMJU
appears at the outside edge of the sprocket tip. (See Fig. V)
3. To rotate the sprocket pull the chain by hand until the ungreased side of the sprocket is in
line with the grease hole. Repeat the lubrication procedure.
a
U
Injecting grease to lubricate
V
Assembly