- 16 -
SolutionPossible CauseProblem
Unit does not
run
Bar and chain
running hot and
smoking
Motor runs but
chain is not ro-
tating
Extension cord not connected to the
plug.
Check extension cord is fully connected to
tool.
Cord not connected to power source.
Check extension cord is fully connected to a
live receptacle.
engaging trigger switch.
TROUBLESHOOTING
Check tension for over-tight condition. Adjust chain tension.
Chain oil tank empty. Fill tank with chain oil.
Chain installed in wrong direction.
Reverse chain so that cutters face the right
direction.
Chain tension is too tight. Adjust chain tension.
Check guide bar and chain for
damage.
Replace damaged bar and chain with
identical replacement parts or contact
our customer service center at 1-888-
497-7273 for assistance.
To Next Page
Loading...
