- 12 -
mately 2 inches
(5cm) or 1/10 the diameter of the tree). This is called
“hinge” or”hinge wood.” It controls the fall of the tree
and prevents slipping or twisting or shoot-back of
On large diameter trees, stop the back cut before
it is deep enough for the tree to either fall or set-
tle back on the stump. Then insert soft wooden or
plastic wedges into the cut so they do not touch the
chain. The wedges can be driven in, little by little, to
help jack the tree over.
WARNING: To avoid serious personal injury,
read and understand all the safety instructions
provided.
DANGER: Before performing any mainte-
nance, make sure the tool is unplugged from the
power supply. Failure to heed this warning could
result in serious personal injury.
CAUTION: Always wear gloves when han-
dling the bar and chain; these components are
sharp and may contain burrs.
WARNING: Never touch or adjust the chain
while the motor is running. The saw chain is very
sharp; always wear protective gloves when per-
forming maintenance to the chain to avoid possi-
ble serious lacerations.
NOTE: When replacing the guide bar and chain, use
only identical replacement parts.
● Disconnect chain saw from power supply. Lay
● Unscrew the locknut counterclockwise from the
chain cover with the hex key provided.
ASSEMBLY
UNPACKING
This product requires some assembly.
PACKING LIST
- Chain Saw
- Guide Bar
- Chain
- Bar Cover
- Combination Hex Key/Screwdriver
- Instruction Manual
Carefully remove the product and any accessories
from the box. Make sure that all items listed in the
packing list are included.
Inspect the product carefully to make sure no break-
age or damage occurred during shipping . Do not
discard the packaging material until you have care-
fully inspected and satisfactorily operated the prod-
uct.
WARNING : If any parts are damaged or miss-
ing do not operate this product until the parts
are replaced. Failure to heed this warning could
result in serious personal injury. Call 1-888-497-
7273 for assistance.
INSTALLING/ RE-
PLACING THE GUIDE
BAR AND CHAIN
DANGER: Never start the motor before in-
stalling the guide bar, and chain. Without these
exposing the user to possible serious injury.
● Remove the chain wheel cover.
Installing/ Replacing The Bar And Chain
and chain).
● Remove the bar and chain assembly from the
mounting surface.
LocknutChain wheel Cover
To Next Page
Loading...
