3-16
183574-1CD
183574-1CD
3 Installation
3.7 Installation of Tooling and Fixtures
ArcWorld 50/50S/52/52S
3.7 Installation of Tooling and Fixtures
The ArcWorld is now ready for attachment of tooling fixtures to the table(s)
or Positioner. YASKAWA recommends assigning this task to personnel
who are familiar with the ArcWorld operation and setup. After installation
of the tooling and fixtures, test the Positioner for correct operation. Refer
to the Positioner manual for instructions on how to test the Positioner for
correct operation
(see section 1.5).
NOTICE
• The customer will supply all tooling and fixtures for the Positioner.
• YASKAWA recommends using a corrosion/rust preventive compound
on tooling and fixtures located in a high-humidity environment.
To Next Page
Loading...