To Next PageTo Next PageWhat to do if YASKAWA Measuring Instruments show Run Command Selection Error?
If your YASKAWA Measuring Instruments display a Run Command Selection Error, it could be due to the frequency reference being assigned to an option that is not connected to the drive. Ensure parameter b1-01 is set correctly. Alternatively, reconnect the option unit to the drive.
How to fix Option Unit Fault in YASKAWA Measuring Instruments?
If you encounter an Option Unit Fault with your YASKAWA Measuring Instruments, the option unit might not be properly connected to the drive. Turn the power off and then reconnect the option unit to resolve this issue.
How to fix MEMOBUS/Modbus Communication Error YASKAWA Recording Equipment?
If you are encountering a MEMOBUS/Modbus communication error with your YASKAWA Recording Equipment, it could be due to data not being received within the CE detection time limit specified by parameter H5-09. This may stem from noise interference or a faulty communication cable connection. To resolve this: * Check the wiring for any looseness or incorrect connections. * Ensure the unit has proper grounding. * Reconnect the leads that connect to the main circuit within the drive. Verify that the DIP switch for terminal resistance is correctly configured.
What to do if Run Command Selection Error on YASKAWA Recording Equipment?
A Run Command Selection Error on your YASKAWA Recording Equipment may occur if the frequency reference is assigned to an option (b1-01 = 2) that is not connected to the drive. To fix this: * Ensure parameters b1-01 and b1-02 are correctly set. * Reconnect the option unit to the drive. Another cause may be that the Run command is assigned to an option (b1-02 = 2) that is not connected to the drive.
General| Series | J1000 |
|---|---|
| Voltage Class | 200V, 400V |
| Frequency | 50/60 Hz |
| Enclosure Rating | IP20 |
| Enclosure Type | Open type |
| Voltage | 200-240V, 380-480V |
| Control Method | V/f control |
| Overload Capacity | 150% for 60 seconds |
| Protection | Overcurrent, Overvoltage, Undervoltage, Overheat, Ground Fault, Short Circuit |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit |
| Humidity | 5-95% (non-condensing) |
| Enclosure | IP20 |
| Input Voltage | 200-240V, 380-480V |
