YASKAWA motoman NX100

 0:

(KPCN RCIG

• Improper operation can result in personal injury and/or damage to the equipment.
Only trained personnel familiar with the operation, manuals, electrical design, and
equipment interconnections of this robot should be permitted to operate the system.
• Inspect the robot and work envelope to be sure no potentially hazardous conditions
exist. Be sure the area is clean and free of water, oil, debris, etc.
• Be sure that all safeguards are in place.
• Check the E-STOP button on the teach pendant for proper operation before
programming.
• Carry the teach pendant with you when you enter the workcell.
• Be sure that only the person holding the teach pendant enters the workcell.
• Test any new or modified program at low speed for at least one full cycle.
 1RGTCVKQP5CHGV[
All operators, programmers, plant and tooling engineers, maintenance personnel,
supervisors, and anyone working near the robot must become familiar with the operation of
this equipment. All personnel involved with the operation of the equipment must
understand potential dangers of operation. Operation tips are as follows:
• Be sure that only trained personnel familiar with the operation of this robot, the
operator's manuals, the system equipment, and options and accessories are
permitted to operate this robot system.
• Check all safety equipment for proper operation. Repair or replace any
non-functioning safety equipment immediately.
• Inspect the robot and work envelope to ensure no potentially hazardous conditions
exist. Be sure the area is clean and free of water, oil, debris, etc.
• Ensure that all safeguards are in place.
• Improper operation can result in personal injury and/or damage to the equipment.
Only trained personnel familiar with the operation, manuals, electrical design, and
equipment interconnections of this robot should be permitted to operate the system.
• Do not enter the robot cell while it is in automatic operation. Programmers must
have the teach pendant when they enter the cell.
• The robot must be placed in Emergency Stop (E-STOP) mode whenever it is not in
use.
• This equipment has multiple sources of electrical supply. Electrical interconnections
are made between the controller, external servo box, and other equipment.
Disconnect and lockout/tagout all electrical circuits before making any modifications
or connections.