Yealink CP860 - Page 183

Configuring Basic Features
171
Parameters
Permitted Values
Default
Description:
Enables or disables the IP phone to display the DTMF digits for a short period before
displaying asterisks during an active call.
0-Disabled
1-Enabled
Note: It works only if the parameter “features.dtmf.hide” is set to 1 (Enabled).
Web User Interface:
Features->General Information->Suppress DTMF Display Delay
Phone User Interface:
None
To configure suppress DTMF display and suppress DTMF display delay via web user
interface:
1. Click on Features->General Information.
2. Select the desired value from the pull-down list of Suppress DTMF Display.
3. Select the desired value from the pull-down list of Suppress DTMF Display Delay.
4. Click Confirm to accept the change.