Yealink CP860 - Page 316

Administrator’s Guide for CP860 IP conference phones
304
Parameters
Permitted Values
Default
Description:
Configures the normal delay time (in milliseconds) of jitter buffer.
Note: It works only if the parameter “voice.jib.adaptive” is set to 0 (Fixed).
Web User Interface:
Settings->Voice->JITTER BUFFER->Normal
Phone User Interface:
None
To configure Jitter Buffer via web user interface:
1. Click on Settings->Voice.
2. Mark the desired radio box in the Type field.
3. Enter the minimum delay time for adaptive jitter buffer in the Min Delay field.
Valid values range from 0 to 300.
4. Enter the maximum delay time for adaptive jitter buffer in the Max Delay field.
Valid values range from 0 to 300.
5. Enter the fixed delay time for fixed jitter buffer in the Normal field.
Valid values range from 0 to 300.
6. Click Confirm to accept the change.