User Guide for the SIP-T20P/SIP-T20 IP Phone
16
To configure PPPoE via phone user interface:
1. Press .
2. Select Settings->Advanced (password: admin) ->Network->WAN Port.
3. Press to select IPv4 and press .
4. Press to select PPPoE and press .
5. Enter the user name and password in the corresponding fields.
6. Press to accept the change.
Note
Generally, your phone will be deployed with multiple other phones. In this case, your
system administrator will configure the phone parameters beforehand, so that after you
start up your phone, the phone will be registered and ready for use. If your phone is not
registered, you may have to register it. For more information on how to register your
phone, refer to Account Management on page 43.
If the phone has successfully started up, the idle screen will be shown as below:
The idle screen shows the label of current account, time and date.
Wrong network settings may result in inaccessibility of your phone and may also have an
impact on your network performance. For more information on these parameters,
contact your system administrator.
To Next Page
Loading...
Need help?
General