EasyManuals Logo

Yealink SIP-T20 User Manual

Yealink SIP-T20
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #99 background imageLoading...
Page #99 background image
Advanced Phone Features
87
Multicast paging key is configurable via web user interface at the path DSSKey->Line
Key.
You can also configure the phone to use a default codec for sending multicast RTP
stream via web user interface.
To configure a default codec for multicast paging:
1. Click on Features->General Information.
2. Select the desired codec from the pull-down list of Multicast Codec.
The default codec is G722.
3. Click Confirm to accept the change.
Note
To send RTP stream:
1. Press the multicast paging key when the phone is idle.
The phone sends RTP to a preconfigured multicast address (IP: Port). Any phone in
the local network then listens to the RTP on the preconfigured multicast address (IP:
Port). For both sending and receiving of the multicast RTP, there is no SIP signaling
involved.
The multicast paging key LED illuminates solid green.
If G722 codec is used for multicast paging, the LCD screen prompts "HD" to indicate that it
is providing high definition voice.
Default codec for multicast paging is configurable via web user interface only.

Other manuals for Yealink SIP-T20

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink SIP-T20 and is the answer not in the manual?

Yealink SIP-T20 Specifications

General IconGeneral
BrandYealink
ModelSIP-T20
CategoryIP Phone
LanguageEnglish

Related product manuals