User Guide for the SIP-T20P/SIP-T20 IP Phone
92
You can leave voice mails for someone else on the SIP-T20P/SIP-T20 IP phone. You can
also listen to the voice mails stored in a centralized location. When receiving a new
voice mail, the phone will play a warning tone and the MESSAGE key LED will illuminate
and the LCD screen will display a flashing icon.
Note
To leave a voice mail:
You can leave a voice mail for someone else when he/she is busy or inconvenient to
answer the call. Follow the voice prompt from the system server to leave a voice mail,
and then hang up.
To configure voice mail access codes via phone user interface:
1. Press .
2. Select Messages->Set Voice Mail.
3. Press or to select the account you want to set.
4. Press to select the proper input mode and then enter the voice mail access
code (e.g., *88).
5. Press to accept the change.
Note
To listen to voice mails:
1. When the phone user interface prompts receiving new voice mails, press
Voice mail access code must be predefined on the system server. Contact your system
administrator for the more information.
To Next Page
Loading...
Need help?
General