EasyManuals Logo

Yealink SIP-T22P Quick Start Guide

Yealink SIP-T22P
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Placing a Call
Answering a Call
Ending a Call
Call Mute and Un-mute
Redial
Call Hold and Resume
To place a call on hold:
Using the handset:
Using the speakerphone:
Using the headset:
Using the handset:
Using the speakerphone:
Using the headset:
Using the handset:
Using the speakerphone:
Using the headset:
1. With the handset on-hook, press .
1. Pick up the handset.
2. Enter the number, and then press the Send soft key.
1. With the headset connected, press to activate the headset mode.
2. Enter the number, and then press the Send soft key.
2. Enter the number, and then press the Send soft key.
Pick up the handset.
Press .
Hang up the handset or press the Cancel soft key.
Press .
Press or the Cancel soft key.
Press the Cancel soft key.
Press to enter the Placed Calls list, press or to select the desired entry, and then press or
the Send soft key.
Press twice when the phone is idle to dial the last dialed number.
To resume the call, do one of the following:
Press to mute the microphone during a call.
Press again to un-mute the call.
If there is only one call on hold, press the Resume soft key.
Press the Hold soft key during an active call.
4
Basic Call Features
Note: During a call, you can alternate between headset, hands-free speakerphone and handset modes by
pressing the HEADSET key, the Speakerphone key or by picking up the handset. Headset mode requires
a headset connected.
Note: You can reject an incoming call by pressing the Reject soft key.
Hang up the handset or press the Cancel soft key.

Other manuals for Yealink SIP-T22P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink SIP-T22P and is the answer not in the manual?

Yealink SIP-T22P Specifications

General IconGeneral
DC-in jackYes
Expansion module supportNo
Ethernet LAN (RJ-45) ports2
Volume controlDigital
Keypad number of keys32
Number of handles included1 pc(s)
Power requirements100 - 240 VAC, 5 VDC
Power consumption (typical)2.6 W
Power consumption (PowerSave)1.5 W
Voice codecsG.722, G.723, G.726
Touchscreen-
Display resolution132 x 64 pixels
Lines quantity- lines
Phonebook capacity300 entries
Number of VoIP accounts3
Security algorithmsHTTPS, SRTP
Flash memory8 MB
Internal memory32 MB
Password protection typeUser
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 90 %
Handset typeWired handset
Product typeIP Phone
Product colorBlack
Weight and Dimensions IconWeight and Dimensions
Depth200 mm
Width185 mm
Height90 mm
Weight770 g

Related product manuals