Yealink SIP-T41P

Advanced Phone Features
145
4. Press the Save soft key to accept the change or the Back soft key to cancel.
Note
To listen to voice mails:
1. When the LCD screen prompts that the phone receives a new voice mail and the
power indicator LED slow flashes red, you can press or the Connect soft key to
dial out the voice mail access code.
2. Follow the voice prompt to listen to your voice mails.
Note
To view the voice mail via phone user interface:
1. Press Menu->Messages->Voice Mail->View Voice Mail.
The LCD screen displays the amount of new and old voice mails.
2. Select an account and then press the Connect soft key to listen to voice mails.
The SIP-T41P IP phone supports MWI feature when receiving a new voice message. If
someone leaves you a voice mail, you will receive a message waiting indicator. MWI
will be indicated in three ways: a warning tone, an indicator message (including a
voice mail icon) on the LCD screen, and the power indicator LED slow flashes red. This
will be cleared when you retrieve all voice mails or delete them.
The MWI service is unsolicited for some servers, so the SIP-T41P IP phone only handles
the MWI messages sent from the server. But for other servers, the MWI service is
solicited, so the SIP-T41P IP phone must enable subscription for MWI.
Note
Voice mail access codes must be predefined on the system server. Contact your system
administrator for the more information.
MWI service is not available on all servers. Contact your system administrator for more
information.
Before listening to voice mails, make sure the voice mail access code has been
configured.
When all new voice mails are retrieved, the power indicator LED will go out.