Yealink T19P

Yealink IP Phones Auto provisioning Guide
68
Parameter
Permitted
Values
Descriptions
Web Setting Path
ateway =
configured as IPv6 or IPv4&IPv6, and
the Internet (WAN) port type for IPv6 is
configured as Static IP Address.
The default value is blank.
It takes effect after a reboot.
IP Address->
Gateway
network.ipv6_
primary_dns
=
IPv6 address
It configures the primary IPv6 DNS
server when the IP address mode is
configured as IPv6 or IPv4&IPv6, and
the Internet (WAN) port type for IPv6 is
configured as Static IP Address.
The default value is blank.
It takes effect after a reboot.
Network->Basic->
IPv6 Config->Static
IP Address->
Primary DNS
network.ipv6_
secondary_dn
s =
IPv6 address
It configures the secondary IPv6 DNS
server when the IP address mode is
configured as IPv6 or IPv4&IPv6, and
the Internet (WAN) port type for IPv6 is
configured as Static IP Address.
The default value is blank.
It takes effect after a reboot.
Network-> Basic->
IPv6 Config->Static
IP Address->
Secondary DNS
network.ipv6_i
cmp_v6.enabl
e =
(only
applicable to
SIP-T48G/T46G
IP phones)
0 or 1
It enables or disables the phone to
obtain IPv6 network settings by
ICMPv6.
0-Disabled
1-Enabled
The default value is 1.
It takes effect after a reboot.
Network->Advanc
ed->ICMPv6
Status->Active
network.bridg
e_mode =
(only
applicable to
SIP-T28P,
SIP-T26P,
SIP-T22P and
SIP-T20P IP
phones)
0 or 1
It configures the PC (LAN) port type.
0-Router
1-Bridge
The default value is 1.
It takes effect after a reboot.
Note: SIP-T19P/T21P/T48G/T46G/
T42G/T41P/ IP phones only support
bridge mode for PC connection.
Network->PC Port
->PC Port Config
network.pc_p
ort.enable =
0 or 1
It enables or disables the PC port.
0-Disabled
Network->PC Port
->PC Port Active