EasyManuals Logo

Yealink T20P User Guide

Yealink T20P
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
User Guide – Yealink T20P
http://www.virtualglobalphone.com Dec - 2014
Is a entry level IP Phone with high-definition audio, a broad range of voice codec’s support. Its easy
to install and inexpensive from to start up for both enterprise and residential users.
YealinkT20P
These instructions are based on using the T20 in its factory default configuration, which obtains a
dynamic IP address automatically from your router using DHCP. For information on configuring your
T20 with a static IP address please refer to the T20 user manual.
For the purpose of this guide we will use the LCD Configuration and web interface to add an account.
The guide also assumes that you have connected the device to a proper power source, Ethernet
cable is connected from the device to switch / router and its obtained a LAN / WAN IP Address. If not
please check with your provider or system administrator and then proceed to below steps.
LCD Configuration
STEP 1 Click on the ‘Menu’ button
STEP 2 Choose “Settings” > “Advanced”
STEP 3 Enter your admin password, the default password is “admin”

Other manuals for Yealink T20P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink T20P and is the answer not in the manual?

Yealink T20P Specifications

General IconGeneral
Lines2
ProtocolsSIP v1 (RFC2543), v2 (RFC3261)
Power over Ethernet (PoE)Yes
PoE SupportYes
Headset PortRJ9
Wall MountableYes
HD VoiceYes
CodecsG.711(A/μ), G.723, G.729AB, G.726
Ethernet Ports2
Dimensions200 mm x 200 mm x 70 mm
Audio FeaturesAcoustic Echo Canceller, VAD, CNG, AEC, PLC, AJB

Related product manuals