Yealink VC200 - Package Contents; Endpoint Installation; Put on a Flat Surface; Mount on top of a TV

TV
TV
The base of the camera must be parallel to the top of TV.
You can adjust the angle of the camera manually. The angle can be up to 30 degree.
Choose other installation method if the thickness of the TV is more than 36 mm.
1
Package Contents
3m
Ethernet Cable
AAA Battery×2
VC200 Codec
VCR11
Remote Control
1.8m
HDMI Cable
(for the display device)
Cable Tie×5
Power Cord
2m Ethernet Cable
(CAT5E FTP cable)
PSE
OK
Quick
Start Guide
1/4”-20 UNC
Screw
We recommend that you use the accessories provided or approved by Yealink. The use of
unapproved third-party accessories may result in reduced performance.
Use the Yealink original PoE adapter (54V/0.56A) to charge the endpoint only. The use of the
third-party PoE adapter may cause the damage to the endpoint.
Put the magnet rings on the HDMI cable to prevent electromagnetic interference.
Endpoint Installation
Select one of the following installation method:
Put on a Flat Surface
You can put the endpoint on a conference room table.
Mount on top of a TV
You can mount endpoint on top of the TV when the thickness of the TV is between 1mm and
36mm.
PoE Adapter
Camera Lens
Privacy cover