Yealink VC500 - Page 3

Endpoint Installation
2
Mount on top of a TV
Select one of the following installation method based on your site requirements:
Put on a Flat Surface
Mount on top of a TV
Mount on a wall
Mount on a ceiling
Mount onto a TV stand or a tripod
.
.
.
.
Put on a Flat Surface
You can put the endpoint on a conference room table, and make sure that the slope is not more than 5 degrees so that the endpoint
can operate correctly.
.
Steps：
1
3
2
4
3
TV
4
3
Push the bracket to an appropriate location.
Remove one Velcro.
Put the bracket on the top of the TV.
Stick a Velcro onto the back of the TV, and make sure that the bracket and the back of the TV are tightly positioned against
each other.
Pay attention to the direction of the bracket
2
1
If your endpoint cannot be mounted on the top of a TV when the
bracket has reached the given location, you should remove the bracket,
and then convert its direction. Refer to the following section for more
information.
The endpoint may fall down when the thickness of the TV is more than 77 mm. In this situation, do not mount the endpoint on the
top of a TV.
Please choose the following installation method when the thickness of the TV is between 1mm and 36mm.