Call Hold and Resume
To place a call on hold:
To resume a call, do one of the following:
If there is only a call on hold, press the Resume soft key.
Press the Options soft key during a call, and select Hold.
If there are two calls on hold, press the Resume soft key to resume the current call,
press the Swap soft key to swap between the two calls.
Call Forward
Call Transfer
1. Press the Options soft key during a call, and select Transfer.
2. Enter the number you want to transfer the call to.
3. Press
To enable the call forward feature on a specific line:
Always----Incoming calls are forwarded immediately.
Busy----Incoming calls are forwarded when the handset is busy.
No Answer----Incoming calls are forwarded if not answered after a period of time.
1. Press the OK key to enter the main menu, and select Call Features->Call Forward.
3. Press or to highlight the desired forwarding type, and press the OK soft key.
5. Enter the number you want to forward the incoming calls to in the Target field.
7. Press the Save soft key to accept the change.
4. Press the Transfer soft key after the call is answered.
2. Press or to highlight the desired line, and press the OK soft key.
4. Select Enabled from the Status field.
6. Press or to select the desired ring time to wait before forwarding (only for No
Answer Forward) in the After Ring Time field.
Call Mute
Press during a call to mute the call.
Press again to un-mute the call.
Configuring your Phone
IP DECT Phone
or the OK key to dial out.
W52
You can transfer a call in the following way:
Quick Site Guide
To Next Page
Need help?
General
