Yealink W52H
IP DECT Phone
Quick Reference User Guide
Page 4 | Copyright © Telair Pty Ltd (ABN 92 119 713 745) | www.telair.com.au | 1800 telair (835 247) Copyright © Telair Pty Ltd (ABN 92 119 713 745) | www.telair.com.au | 1800 telair (835 247)
ACCESS VOICEMAIL
1. Press .
2. When prompted, enter PIN-Code and press .
• For new messages, press .
• For saved messages, press .
• For advanced voicemail settings, press .
PLACE CALL ON HOLD/RESUME A CALL
To place a call on hold:
• Press the Options soft key during a call, and select Hold.
To resume a call, do one of the following:
• If only one call is on hold, press the Resume soft key.
• If there are two calls on hold, press the Resume soft key to resume the current call. Press the
Swap soft key to swap between calls.
TRANSFER A CALL
Blind Transfer - The call is transferred directly without the need to announce the caller:
• Press the Options soft key during a call, and select Blind ransfer.
• Enter the number you wish to transfer the call to.
• Press the Transfer soft key.
Attended Transfer - Allows you to announce the caller prior to releasing the call
• Press the Options soft key during a call, and select Transfer.
• Enter the number you wish to transfer the call to.
• Press the Transfer soft key to dial out.
• Press Transfer after announcing the call to the third-party.
ENABLE CALL FORWARD
To enable Call Forward on a specific line:
• Press the OK key to enter the main menu, and select Call Features > Call Forward.
• Press or to highlight the desired line, and press the OK soft key.
• Press or to highlight the desired forwarding type, and press the OK soft key.
• Always----Incoming calls are forwarded immediately.
• Busy----Incoming calls are forwarded when the line is busy.
• No Answer----Incoming calls are forwarded if not answered after a period of time.
• Select Enabled from the Status field.
• Enter number to forward to in the Target field and press the Save soft key to accpet the change.
How to (cont...):
To Next Page
Need help?
General
