Yealink W52P - Quick Installation Guide Manual

Network Settings
Getting Started
To configure the network parameters for the base station manually:
1. Press the OK key to enter the main menu, and select Settings->System Settings->
3. Select Static from the IP Address Type field.
Network.
2. Enter the system PIN (default: 0000), and press the Done soft key.
4. Enter the valid values in the IP Address, Subnet Mask, Default Gateway, Primary DNS and
Secondary DNS fields.
DHCP----By default, the base station attempts to contact a DHCP server in your network to
obtain the valid network settings, e.g. IP address, subnet mask, gateway, DNS
server.
Static----If the base station cannot contact a DHCP server for any reason, you need
to configure the IP address, subnet mask, gateway, primary DNS and secondary
DNS for the base station manually.
You can configure the base station to obtain the network settings in one of the following
ways:
Note: The wrong network settings may result in inaccessibility of your phone and may have an
impact on the network performance. For more information about these parameters, contact
your system administrator.
Configuring your Phone
Quick Installation Guide
www.yealink.com
For more information, refer to the User Guide available online at:
http://www.yealink.com/DocumentDownload.aspx?CateId=142&flag=142.
Copyright 2013 YEALINK NETWORK TECHNOLOGY CO.,LTD.
c
W52P & W52H
IP DECT Phone
Shortcuts
The handset in the W52P package is pre-registered to the base station. The internal
handset number and the handset name display on the idle screen after turning the
handset on.
Note: If your handset is not pre-registered to the base station, you need to register it manually. For
more information, refer to Yealink W52P IP DECT Phone User Guide.
Handset Registration
You can press the following predefined shortcut keys to access some frequently used
features of your handset when the handset is idle:
Press to access the call history.
Press to check the line status.
Press to place an internal call.
Press to access the directory.
Press to decrease the ringer volume.
5. Press the Save soft key to accept the change.
This helps you get quick access to features by pressing the shortcut keys directly without
having to scroll through the menu.
Applies to firmware version 10 or later.
Press to increase the ringer volume.