Yealink W59R - Page 5

3
E
N
G
L
I
S
H
Registration on the Web User Interface
Registering W90B to the W90DM
Registering a Single Handset to the W90B
In the multicast network, the W90B can be automatically detected by
the W90DM. You can register the W90B to the W90DM via the web user
interface.
1. Navigate to Base Station > Base Station Registration.
2. Click next to the base station.
3. Complete the corresponding information of the base station, and click
OK.
The base station is successfully registered to the DM.
1. Navigate to Handset & Account > Handset Registration.
2. Click Add Handset.
3. Click Start Register Handset to set the DM to the registration mode.
4. On the handset, do one of the following:
• Press the Reg soft key on the handset to register quickly.
• Press OK > Register Handset and then select the desired base to reg-
ister the handset.
• Press OK > Settings > Registration > Register Handset and then
select the desired base to register the handset.
After registration, the handset prompts “Handset Subscribed”.
Note: In the non-multicast network, the W90DM can detect and connect the W90B
only when you have congured the DM's IP address via W90B web user interface or
via auto provisioning.