Step3: Connect Base to power and network
Step4: Get IP address of DM
(W80B has 3 modes: DM mode, DM+Base mode, Base mode. Default mode is Base mode)
1) Change Base to DM-base mode by quick press pairing key three times. When you see the light
below, that means it is on DM-Base mode.
2) Long press the Pairing button on W80B until you see the DECT LED slow flash. Now it is on
registering status.
3) On handset, press Reg key. In about 2 seconds, you will see the handset registered to DM+Base.
4) On handset, go to Status—DM to check the IP address of the DM.
To Next Page
Loading...
