NeoGate TA Series Installation Guide
19/20
Via the configuration interface, the admin can make all the system configurations, including
network settings (LAN, WAN, Firewall, VPN, DDNS, VLAN, etc.); system parameters configuration
(time zone, password, etc.); internal settings (Web access port, etc.); FXS ports list; FXO ports list;
Hunting Groups; Hotline; call logs (search, download); firmware update and reset, etc.
After saving the changes, remember to click the “Apply changes” button to make the
changes take effect.
4.3 Network Settings
After logging in the admin configuration interface, generally the first step is to configure the IP
address. If the LAN ports are connected to the network, their IP addresses need to be configured.
If not, just configuring the IP address of the LAN port which is connected to the local area
network of the company is OK.
LAN Settings
Click “Network Preferences”-> “LAN Settings” on the left menu bar of the web configuration
interface. LAN port is used for the interoperability of IP terminals and NeoGate. If the LAN
port is connected to the company’s LAN, please configure the correct IP address and
corresponding subnet mask.
Please note that after changing the IP address of LAN port, NeoGate should be rebooted to
make the new changes to take effect.
4.4 Make and Receive Calls
NeoGate TA FXS Gateway
1. Internal calls between FXS ports
Two analog phones connected to NeoGate TA could make calls between them by dialing *99+FXS
port number.
2. Outbound and inbound calls
Users should be able to make and receive external calls after configuring FXS Ports, VoIP Server,
and Dial Pattern. Please refer to NeoGate TA FXS Gateway User Manual for details.
NeoGate TA FXO Gateway
1. Route calls from a PSTN number to IP-PBX
Users should be able to receive PSTN-to-VoIP call after configuring FXO Ports, VoIP Server, Dial
Pattern and Port -> IP. Please refer to User Manual for details.
2. Route calls from VoIP trunk to a PSTN number
Users should be able to make VoIP-to-PSTN call after configuring FXO Ports, VoIP Server, Dial
Pattern and IP -> Port. Please refer to NeoGate TA FXO Gateway User Manual for details.
To Next Page
Loading...
Need help?
General
