NeoGate TA Series Installation Guide
20/20
4.5 Reset to Factory Defaults
To reset to factory defaults, you could follow the below instruction:
Press the “RESET” button located in the back panel with a paper clip or a pencil tip. You can see
the RUN indicator stops flicker and turns solid. When the RUN indicator turns off, the button
could be released and system begins to reset. During the process, please do not power off until
the RUN indicator become normal which means the reset process is completed.
Note: After resetting, all the configurations made by the admin would be erased.
5. Conclusion
This Installation Guide only explains the installation and basic settings of NeoGate TA Series
Analog VoIP Gateways. For more functionality and advanced settings, please refer to the relative
documents as below:
“NeoGate TA Series Analog VoIP Gateways Datasheet”
“NeoGate TA FXS Gateway User Manual”
“NeoGate TA FXO Gateway User Manual”
[The End]
To Previous Page
Loading...
Need help?
General
