NeoGate TG Series User Manual
55/62
2) Advanced route
Figure 7-30
When simple mode is set as “No”, you can check the advanced settings.
Route name A name for this route
Call Source Choose the trunk where incoming call comes from
Inbound caller pattern
M
atch the prefix of caller ID for incoming calls.
Hover the pointer over to read tips.
Enable Callback
Choose whether call back is enabled,
configure the advanced call back settings in part:
7.3.4.
Call Destination Choose the destination trunk to route the call to
Hotline
When it’s configred, this number will be dial via
destination trunk permanently
Outbound Dial Pattern
Outbound
calls that match this dial pattern will
use this outbound route. Hover the pointer over
Strip digits from front
before dialing
Allow the user to specify the number of digits that
will be stripped from the front of the phone
number before the call is placed.
Prepend these digits before
These digits will be prepended to the phone
number before the call is placed
To Next Page
Loading...
Need help?
General
