NeoGate TG Series User Manual
8/62
2.3 Ethernet Line Connection
NeoGate provides two 10/100M Ethernet ports with RJ45 interface and LED
indicator. Plug Ethernet line into NeoGate’s Ethernet port, and then connect
the other end of the Ethernet line with a hub, switch, router, LAN or WAN. Once
connected, check the status of the LED indicator. A yellow LED indicates the port
is in 100M mode, if it’s dark, the speed is 10M. Green LED indicates the port is
properly connected, if it’s flickering, it means data transmission.
2.4 Power Supply Connection
NeoGate utilizes the high-performance switch power, which supplies enough
voltage and electrical energy required by NeoGate system.
AC Input: 100~240V
DC Output: 12V, 1A
Please follow the steps below to connect the NeoGate unit to a power outlet:
1. Connect the small end of the power cable to the power input port on the
NeoGate back panel, and plug the other end of the cable into a 100VAC power
outlet.
2. Check the Power LED on the front panel. A solid green LED indicates that
power is being supplied correctly.
3 Administrator Login
Open your Web browser and input the IP address of the NeoGate server.
If this is the first time you configure NeoGate, please use the default settings
below:
IP Address: http://192.168.5.150
Username: admin
Password: password
In this example, the IP address is 192.168.2.135, the model is TG800.
To Next Page
Loading...
Need help?
General
