1.Press <MENU> repeatedly until DENO shows on the display.
2.Press <ENTER>.
Sound-Active Mode
To run the 36LEDs Par Light in sound-active mode, do the following:
1.Press <MENU> repeatedly until SOUD shows on the display.
2.Press <ENTER>.
Custom Color Mixing
To custom mix a static color, follow the instructions below:
1.Press <MENU> repeatedly until RGB shows on the display.
2.Press <ENTER> and one of the following will show on the display:
r_ _ _ (red)
g_ _ _ (green)
b_ _ _ (blue)
3.Press <ENTER> to cycle through the color settings.
4.When the desired color shows on the display, use <UP> or
<DOWN> to increase or decrease the color value.
5.Repeat steps 3 and 4 until the product outputs as desired.
For example, to get red color, set r255,g000,b000.
Fade mode 1 ( slower)
To run the color fading mode 1, do the following:
1.Press <MENU> repeatedly until Cf01 shows on the display.
2.Press <ENTER>.
3.Use <UP> and <DOWN> to increase or decrease the program
speed(Cf01-Cf99)
4.Press <ENTER>.
-10-
To Next Page
Loading...