YeeSite 36LEDs - DMX Linking and Configuration; DMX Personality and Starting Address

DMX Linking
The 36LEDs Par Light works with a DMX controller.
Configuration(DMX)
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2.Connect a DMX cable from the DMX output of the DMX controller
to the DMX input socket on the product.
DMX Personality and Starting Address
When selecting a starting DMX address, always consider the
number of DMX channels the selected DMX mode uses. If you
choose a starting address that is too high, you could restrict the
access to some of the product’s channels.
The 36LEDs Par Light uses 4 DMX channels or 7 DMX channels
and defines the highest configurable address to 511
To select the starting address, do the following:
1.Press <MENU> repeatedly until A001 or D001 shows on the
display.
2.Press <ENTER> and A001 –A511 or D001-D511 will show on
the display.
3.Use <UP> or <DOWN> to select the starting address.
4. Press <ENTER>.
-8-