YeeSite 36LEDs - Master;Slave Mode (wired)

Fade mode 2 ( faster)
To run the color fading mode 2, do the following:
1.Press <MENU> repeatedly until Cp01 shows on the display.
2.Press <ENTER>.
3.Use <UP> and <DOWN> to increase or decrease the program
speed(Cp01-Cp99)
4.Press <ENTER>.
Hopping mode
To run the hopping mode, do the following:
1.Press <MENU> repeatedly until Cj01 shows on the display.
2.Press <ENTER>.
3.Use <UP> and <DOWN> to increase or decrease the program
speed(Cj01-Cj99)
4.Press <ENTER>.
Strobe mode
To run the strobe mode on 36LEDs Par Light, follow the
instructions below:
1.Press <MENU> repeatedly until Ct01 shows on the display.
2. Press <ENTER>.
3.Use <UP> and <DOWN> to increase or decrease the program
speed(Ct01-Ct99)
4.Press <ENTER>.
Master/Slave Mode (wired)
The Master/Slave mode allows a single 36LEDs Par Light product
(the “master”) to control the actions of one or more 36LEDs Par
Light products (the “slaves”) without the need of a DMX controller.
The master product will be set to operate in any Stand-Alone
mode, while the slave products will be set to operate in Slave
-11-