-5-
3. SETUP
AC Power
The 36LEDs Par Light has an auto-ranging power supply and it
can work with an input voltage range of 110 to 240 VAC, 50/60 Hz.
To determine the product’s power requirements (circuit breaker,
power outlet, and wiring), use the current value listed on the label
affixed to the product’s back panel, or refer to the product’s
specifications chart. The listed current rating indicates the
product’s average current draw under normal conditions.
Always connect the product to a protected circuit (circuit breaker
or fuse). Make sure the product has an appropriate electrical
ground to avoid the risk of electrocution or fire.
To eliminate unnecessary wear and improve its lifespan, during
periods of non-use completely disconnect the product from
power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or
dimmer circuit, even if the rheostat or dimmer channel serves
only as a 0 to 100% switch.
Mounting
Before mounting the product, read and follow the safety
recommendations indicated in the Safety Notes.
Orientation
The 36LEDs Par Light may be mounted in any position; however,
make sure adequate ventilation is provided around the product.
Rigging
Before deciding on a location for the product, always make sure
there is easy access to the product for maintenance and
programming purposes.
To Next Page
Loading...