22
www.yellowtec.com I info@yellowtec.com
Memory
Insert three AA batteries to the battery compartment. Three AA batteries
will provide a minium of 6 hours of operating time.
Use the interal Li-Ion battery and the AA batteries together to get a mini-
mum of 14 hours of recording time.
NOTE: It‘s not recommended to use rechargable
AA batteries.
How can I extend my operating time?
Which batteries can I use?
Capactiy calculation will not work properly if you are using rechargable
AA batteries. (see: `How to check my battery capacity‘)
Use three (AA) batteries in addition to the internal Li-Ion battery. They
will add to the total of your iXm‘s battery capacity. Power management
will automatically switch power sources if necessary. The use of AA
batteries is not necessary to operate the iXm. The internal Li-Ion battery
is fully able to operate your iXm up to 8 hours.
When using AA batteries make sure you insert them correctly (check
polarities).
Your iXm supports any SD/HC cards regardless of it‘s storage capacity.
NOTE: Remember that a memory card has to be inserted at all
times in order to operate the iXm.
Insert the Card into the SD Card slot of the Port Panel. Make sure your SD
card latches properly. Depending on the memory‘s storage capacity, the
duration of the iXm‘s boot sequence will vary slightly.
Which memory cards can I use?
Check the iXm‘s remaining SD Card capacity by hitting the STOP Key (2) on
the Record Keypad. The MEM LED will flash amber once for every hour of
recording time that is left.
NOTE: Checking your memory will also cause a battery check
(see chapter: How do I check my battery capacity)
To Next Page
Loading...
