29
www.yellowtec.com I info@yellowtec.com
Installation
The User Software provides status information and fewer options to
allow a fast setup for some of the most important settings needed for
field operations.
The Admin Software will give you a more extended access to the
options and setups of your iXm Recorder Microphone. The Admin
Software is also password secured, can save up to nine different micro-
phone setups and allows you to update your firmware and change your
passwords.
Starting the Software
The installation folder of your Software is set to C:\Programs\Yellowtec
iXm
You will find two Software Applications. The User Software and the
Admin Software. To get more information about the difference bet-
ween the Softwares please check out the Chapters: User Software and
Admin Software.
The Software will connect to the device once you have selected the
proper COM Port and pressed the `Connect‘ button.
When you enter the Admin Software you will be asked for a username
and password! The initial password for `admin‘ and `superadmin‘ is:
username: admin / superadmin
password: qwe123asd
NOTE: The SuperAdminisitrator can add or remove users,
set or change passwords and update your firmware
You are now ready to configure your iXm‘s settings, save different se-
tups for different recording scenarios, set or change passwords, update
your iXm‘s firmware or disable the LEA Engine!
To Next Page
Loading...
