18
IM AQ6370D-02EN
2.
Turn ON the MAIN POWER switch on the rear panel of the instrument. The
POWER switch on the front panel of the instrument lights orange.
100
-
240V
150VA
FUSE
AQ6370D-02, -12, -22 AQ6370D-01, -10, -20
3.
Press the POWER switch on the front panel of the instrument. The color of
the switch turns from orange to green. The operating system starts up, and
initialization of the instrument begins. The instrument will not start for a few
seconds immediately after step 2 even if you press the POWER switch.
USB
POWER
The initialization screen appears, and the internal initialization process starts. STEP
1/9 through STEP 9/9 are displayed in the lower right part of the screen to indicate
the progress of initialization.
CAUTION
Do not press the POWER or MAIN POWER switches while initialization is in
progress. Doing so can cause malfunction.
French
ATTENTION
N’appuyez pas sur les interrupteurs POWER ou MAIN POWER pendant
l’initialisation. Cela pourrait provoquer des dysfonctionnements.
Operations Performed When the power is Turned On
If initialization finishes successfully, a message appears prompting you to execute
wavelength calibration and alignment adjustment.
8 Turning the Power ON/OFF
To Next Page
Loading...
Need help?
General
