27
IM AQ6370D-02EN
Item Specifications
Electrical interfaces GP-IB, RS-232, Ethernet, USB, SVGA output, analog output port, trigger input port, trigger
output port
Remote control
12
GP-IB, RS-232, Ethernet (TCP/IP)
AQ6317 series compliant commands (IEEE488.1) and IEEE488.2
Data storage
Internal storage 512 MB or higher
External storage USB storage media (USB memory/HDD), format: FAT32
File types CSV (text), binary, bitmap, TIFF
Display
13
10.4" color LCD (resolution: 800 x 600 pixels)
External dimensions Approximately 426 (W) x 221 (H) x 459 (D) mm (excluding the protector and handle)
Mass Approximately 19 kg
Power requirement 100 to 240 VAC, 50/60 Hz, approximately 100 VA
Environment conditions Optimal temperature: +18 to +28°C
Operating temperature range: +5 to +35°C
Storage temperature range: -10 to +50°C
Ambient humidity: 20 to 80% RH or less (no condensation)
Recommended calibration period 1 year
Function
Measurement
Setting of measuring conditions Center wavelength, span, wavelength sampling points, wavelength resolution, measurement
sensitivity, high dynamic mode, average count (1 to 999), double-speed measurement mode,
smoothing, APC level correction
Sweep settings Single sweep, repeat sweep, AUTO (automatically sets measuring conditions), sweep
between marker, data logging
Measurement function CW measurement, pulse light measurement, external trigger measurement, gate
measurement, air/vacuum wavelength measurement
Other Sweep status output, analog output
Display
Vertical scale Level scale (0.1 to 10 dB/div, linear), level subscale (0.1 to 10 dB/div, linear), reference level
display, DIV display (8, 10, 12), percentage display, dB/km display, power density (dB/nm)
display, noise mask
Horizontal scale Horizontal wavelength (nm) display, frequency (THz) display, zoom in/zoom out display
Display mode and items Single waveform display, split screen display, data table display, label display, template
display, measurement condition display
Trace
Display function Simultaneous display of 7 independent traces, max/min value detection display, calculation
between traces display, normalized display, roll averaging (sweep average) display (2 to 100
times), curve fit display, peak curve fit display, marker curve fit display
Other Trace copy, trace clear, write mode fixed mode setting, show/hide setting
Marker and search
Marker Delta marker (1024 points max.), vertical/horizontal line markers, advanced marker
Search Peak search, bottom search, auto search (ON/OFF), search between vertical axis line
markers, search within zoom area
Data analysis
Analysis feature Spectral width analysis (threshold, envelope, RMS, Peak-RMS, notch), WDM (OSNR)
analysis, EDFA-NF analysis, filter peak/bottom analysis, WDM filter peak/bottom analysis,
DFB-LD analysis, FP-LD analysis, LED analysis, SMSR analysis, power analysis, PMD
analysis, Pass/Fail judgment from template
Other Auto analysis execution setting, analysis between vertical axis line markers, analysis within
the zoom area
Auto measurement
Programming 64 programs, 200 steps/program
Other
Alignment Auto alignment using built-in calibration light source (when the built-in light source
specification is -L1) or an external light source
Wavelength Calibration Auto wavelength calibration using built-in calibration light source (when the built-in light
source specification is -L1) or an external light source
Resolution calibration User-defined resolution calibration using an external light source (DFB-LD)
11 Specifications
To Next Page
Loading...
Need help?
General
