YOKOGAWA MT300 Adjustment Manual

8/12 IM MT300-71JA
List of Commands
Command Function Page
CALibrate Group
:CALibrate:DA:ADJust:MFULl
Sets the full-scale negative adjustment value of the D/A output. 9
:CALibrate:DA:ADJust:PFULl
Sets the full-scale positive adjustment value of the D/A output. 9
:CALibrate:DA:ADJust:ZERO
Sets the zero point adjustment value of D/A output. 9
:CALibrate:DA:DATE?
Queries the date when the adjustment value of D/A output was written. 9
:CALibrate:DA:INITialize
Initializes the adjustment value of D/A output. 9
:CALibrate:DA:POINt
Sets or queries the adjustment point of the D/A output range to be adjusted. 10
:CALibrate:DA:RANGe
Sets or queries the D/A output range to be adjusted. 10
:CALibrate:DA:WRITe
Writes the adjustment value of D/A output. 10
:CALibrate:DMM:ADJust:MFULl
Sets the full-scale negative adjustment value of the voltage/current
measurement.
10
:CALibrate:DMM:ADJust:PFULl
Sets the full-scale positive adjustment value of the voltage/current
measurement.
10
:CALibrate:DMM:DATE?
Queries the date when the adjustment value of voltage/current measurement
was written.
11
:CALibrate:DMM:INITialize
Initializes the adjustment value of voltage/current measurement. 11
:CALibrate:DMM:MEASure?
Queries the measured voltage/current. 11
:CALibrate:DMM:POINt
Sets or queries the adjustment point of the measurement range of the
voltage/current measurement to be adjusted.
11
:CALibrate:DMM:RANGe
Sets or queries the measurement range of the voltage/current measurement
to be adjusted.
11
:CALibrate:DMM:WRITe
Writes the adjustment value of voltage/current measurement. 11
:CALibrate:FUNCtion
Sets or queries the adjustment target (voltage/current measurement, D/A
output).
12
:CALibrate:PASSword
Enters the password for switching to adjustment mode. 12

YOKOGAWA MT300 Specifications

General

Brand	YOKOGAWA
Model	MT300
Category	Measuring Instruments
Language	English