Setting
When the YN622N II using master control mode(refet to
p15) , the manual output values of the master unit and
manual output value of YN622N II convert as below:
Manual Flash Output Control(remote control mode)
YN622N II provides a general way of manual control of
the flash output . For the same manual flash output values
of YN622N II, even using different GN of the flash, the
output is the same (in case not exceed the effective range
of the flash).
The minimum manual flash output value of YN622N II is
1, the maximum flash output according to different GN of
the flash, the default value is 8, add 1/3 step is 10.4, add 1
step is 16, and so on. The value of YN622N II is proportional,
when the value A is twice as B, the flash output of the
former is half of the latter, refer to the form below.
※ When setting the flash mode and parameters on the
transmitter, the screen of the flash on the receiver will not
change.
※ R e s t a r t t h e t r a n s m i t t e r w i l l r e s t o r e t h e d e f a u l t
co m p e n s a t io n o r t h e f l a sh o ut p u t s e t ti n g . ( i -T T L
compensation=0 /Value of Manual flash=8)
※ When the setting parameters reach the maximum or
minimum, the corresponding indicator will not blink.
11
Master
Master
YN622N II
YN622N II
1/128 1/64
1/8
16
20.8
27.2
32
41.6
54.4
64 83.2
108.8 128
1.0 1.3
1.7
2.0 2.6 3.4 4.0 5.2
1/4
1/32
1/1
1/16
+0.3
+0.3 +0.3 +0.3
+0.3 +0.3 +0.3+0.7
+0.7 +0.7 +0.7
+0.7 +0.7 +0.7
6.8 8.0
10.4 13.6
16
20.8
27.2
32
41.6
54.4
64 83.2
108.8 128
1.0 1.7
1.3
2.0 2.6 3.4 4.0 5.2 6.8 8.0
10.4 13.6
To Next Page
Loading...
Need help?
General
