Setting
Enable/disable (stand by)
7.Flash Shutter Sync:
Refer to the camera’s setting. Supports front-curtain
sync, rear-curtain sync and high speed synchronous
(HSS/Auto FP*).
*Using high-speed synchronization need to set the flash
sync speed of the camera to AUTO FP.
*The maximum high-speed synchronization speed is
1/8000s or 1/4000s (depends on the camera).
*Some models of camera does not support the HSS
(without Auto FP option), the shutter speed will be
limited to 1/250s or less when using this kind of camera.
※ It need to using single AF of the camera.
※ Both the receiver and the off-camera flash on the
receiver will not be emitted.
8.AF Assist Beam Emitter
When using AF under low-light, the
built-in AF-assist beam emitter of the
transmitter will be emitted automatically
to make it easier to autofocus, and the
on-top flash which support AF assist
beam emitter function can also be
emitted at the same time.
12
State
Operate
Press [ ]button
less than 3 seconds
Channel
indicator
AF assist
beam emitter
On
Off
Blinking
three times
Enable
Disable
Enable/Disable
Press [ ]button
more than 3 seconds
To Next Page
Loading...
