Purchase corresponding PC flash sync cord according to
the different ports of the flashes needs .
1. Use an end of PC sync cord with nut to connect to the receiver.
2. The other end of the PC sync cord connects to strobe flashes
or other flashes which supporting PC port.
3. Set the camera's shutter sync as front-curtain or rear-curtain.
4. Adjust shooting parameters and shoot.
* Super sync: Use the non-high speed sync flash to realize
higher sync speed, this function is more applicable to strobe
flashes whose flash duration is longer, and it is for the camera
which support Auto FP only.
1. Connect the receiver to flash via PC port and it may needs
setting at manual full-power flash output (1/1).
2 . Set the flash sync speed of the camera as AUTO FP, the
maximum shutter sync speeds can reach to 1/8000s. Take
photos and check whether the photos are synchronous , it
may see gradations or variations in the photos, results
depend on the camera and flash.
※ The PC port is for output using only.
※ Flashes on the hot shoe and connecting to the PC port
can be used at the same time.
4.PC Port Triggering (Support Super Sync *)
16
Caution! Do not connect to the PC
port any flash requiring trigger
voltage more than 300V, or the
transceiver may be damaged.
Usage
To Next Page
Loading...
Need help?
General
