Factory Reset
1.)Hold down【 】+【GP/MODE】
button at the same time.
2.)The indicator light will light up in
sequence from A→B→C→C1→C2→
C3→state indicator (red).
3.)Loose all the buttons will restore
factory reset.
17
5. The single contact camera/flash: Manually
setting the flash output
1).Transmitting group setting: According to the
transmitter group setting method 2(P9).
2).Flash mode setting (on the flash):Set to manual
flash mode, use the transmitter's main flash trigger
contact; but it does not support high synchronous
s p ee d o r o th e r T T L fu n c t i o n (t h e m ax i mu m
synchronous speed is 1/250s or less).
Usage
About the Max Sync Speed
About Automatic Saving Function
It needs the camera and flash both support hi-speed
sync, and the max sync speed is 1/8000s or 1/4000s.
When using the hot shoe flash which doesn’t support
hi-speed sync, the max sync speed is 1/250s or lower.
The transceiver will auto saving the sets such as
channel, receiving group, AF assist beam. The exposure
compensation and flash output will not be saved.
To Next Page
Loading...
Need help?
General
