O W N E R ’ S G U I D E
RISK WARNING
FAILURE TO FOLLOW THE PROCEDURES BELOW MAY RESULT IN SERIOUS INJURY DUE TO THE OPERATION OF THE
PINCH POINT AREA BETWEEN THE RUNNING GEAR AND THE UPRIGHT FRAMES.
• DO NOT TIP THE BOX ON ITS SIDE WITH THE TREADMILL STILL IN IT.
• DO NOT MOVE THE TREADMILL OUT OF THE BOX UNTIL THE UNIT HAS BEEN ASSEMBLED
1. LAY BOX ON A STABLE, FLAT SURFACE AND ENSURING THE TOP SIDE IS FACING UP.
2. COLLAPSE ALL FOUR SIDES OF THE BOX BEFORE COMMENCING UNIT ASSEMBLY IN ACCORDANCE WITH THE ASSEMBLY
INSTRUCTIONS.
3. ONCE ASSEMBLED, ONLY MOVE THE TREADMILL OUT OF THE BOX ON ITS WHEELS WHILE THE DECK IS IN THE FOLDED AND
LOCKED POSITION.
• DO NOT REMOVE THE SAFETY PIN THAT IS CONNECTED TO THE SIDE FRAME AND UPRIGHT POST UNTIL YOU HAVE READ
AND FOLLOWED THE ASSEMBLY INSTRUCTIONS.
• ONCE ASSEMBLED AND REMOVED FROM THE BOX DO NOT TIP THE TREADMILL ON ITS SIDE.
ALWAYS READ THESE INSTRUCTIONS AND USE THIS PRODUCT STRICTLY IN ACCORDANCE WITH THIS SAFETY
INFORMATION - KEEP THIS NEAR OR ON THE PRODUCT AT ALL TIMES FOR EASE OF REFERENCE. WHILST USING
THE PRODUCT THERE ARE RISKS AND THE PRODUCT MUST ONLY BE USED AFTER READING AND THEN ONLY IN
ACCORDANCE WITH THESE SAFETY INSTRUCTIONS.
TREADMILL
MONZA SERIES
JAN18/2010
To Next Page
General
