Wired Zone Controller DWCPXY
7
Fig.3.5.2 Timer “On” Setting under the “Off” State of the Unit
Timer range: 0.5 hr. to 24hrs. Every press of ▲or ▼ will increase or decrease the set time by
0.5 hr. If either of them is pressed continuously, the set time will increase/decrease by 0.5 hr. every
0.5 second.
3.6 Swing Setting
Swing On: Press “Function ”in the “On” state of the unit to activate the swing function. In this case,
will blink. After that, press Enter/Cancel to confirm.
Swing Off: When the Swing function is “On”, press “Function” to enter the Swing setting interface
seen as blinking. After that, press “Enter/Cancel” to cancel this function.
The Swing setting is shown in Fig.3.6.1 below.
Turn off the unit without Timer
activated.
Press Timer repeatedly until
reaching setting status.
Press Enter/Cancel to confirm
the setting.
To Next Page
Loading...
