Wired Zone Controller DWCPXY
15
4.3 Removal of the Wired Zone Controller
5 Errors Display
If there is an error occurring during the operation of the system, the error code will be displayed on
the LCD, as
show in Fig.5.1. If multiple errors occur at the same time, their codes will be
displayed in a sequential fashion.
Note: If an error code is displayed, reference Table 5.1 below for error code explanation and
contact you service representative for further assistance.
Fig.5.1
Table 5.1 Definition of Each Error
Return air temperature sensor open/
short circuited
Drive board communication error
Evaporator temperature sensor open/
short circuited
Compressor overheating protection
Indoor unit liquid valve temperature
sensor open/short circuited
Indoor and outdoor units unmatched
Indoor gas valve temperature sensor
open/ short circuited
Communication line misconnected or
expansion valve error
IPM temperature sensor open/short
circuited
Outdoor ambient temperature sensor
open/ short circuited
Outdoor unit condenser mid-tube
temperature sensor open/short circuited
Jumper error