Wired Zone Controller DWCPXY
14
Fig.4.2
Fig.4.2 shows the installation steps for the wired zone controller. Pay attention to the following
before completing the installation.
1)
Prior to the installation, first DISCONNECT THE POWER SUPPLY of the wire buried in the
installation opening. No operation should be performed with the power on during the entire
installation.
2)
Pull out the four conductor twisted pair cable from the installation opening and then place it
through the rectangular opening behind the soleplate of the wired zone controller.
3) Place the soleplate of the wired zone controller on the wall over the installation opening
and secure it with screws M4X25.
4)
Insert the four conductor twisted pair cable into the slot of the wired zone controller and then
secure the front panel and the soleplate of the wired zone controller together.
5) Finally, secure the front panel and the soleplate of the wired zone controller tightly with
screws ST2.9X6.
To Next Page
Loading...
