Wired Zone Controller DWCPXY
9
Fig.3.7.1. Sleep Setting
3.8 Turbo Setting
Turbo function: The unit at the high fan speed can realize quick cooling or heating so that the room
temperature can quickly approach the setting value.
In the Cooling or Heating mode, press “Function” until the unit enters the Turbo setting status. Then
press “Enter/Cancel” to confirm the setting.
When the Turbo function is activated, press “Function” to enter the Turbo setting status. Then press
“Enter/Cancel” to cancel this function.
Turbo function setting is shown in Fig.3.8.1 below.
Press Function repeatedly until
reaching the Sleep setting status.
Press Function repeatedly until
reaching the Sleep setting status
again.
To Next Page
Loading...
